Welcome, Guest
Username: Password: Remember me

TOPIC: Methodology in faring

Methodology in faring 2 weeks 1 day ago #5422

  • krisodland
  • krisodland's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 3
  • Thank you received: 1
  • Karma: 0
Dear all!

After initial shaping of a hull, I want to start the fairing (delftship PRO). I'm new to this software and need help in what methodology/steps to use.

I know that You can add controll curves and used the fairing fuction, but my experience is that if I use fairing button, points along the curve are going in all directions, while I may want to keep for instance same Z-position for a waterline. Is there, for instance, some way to lock points from moving in one direction (x,y,z) during fairing? Do I convert control curves into marker curves and try to fit the surface into these?

Also, there is a "fairing" button in the "point section" window. When should I use this fuction?

I appreciate all the help I get.

sketch.png


Kristian
The administrator has disabled public write access.

Methodology in faring 1 week 2 days ago #5443

We appear to have 2 topics running, starting from basically the same initial post. The other is #5423, to which I posted a response.

Look for this parallel, but further developed topic.

Peter Edmonds
Naval Architect
Perth, Western Australia
The administrator has disabled public write access.
Time to create page: 0.258 seconds
Powered by Kunena Forum